Overall Dimensions and Installation Drawing of VA7010 Series Switching Electric Valve for Fushan Valve

Overall Dimensions (Technical Department of Suzhou Fushan Valve Business Center)

Material Description

Valve body material: forged brass valve stem material: stainless steel ALSL302

Sealing material: nitrile rubber NBR drive chassis: die cast aluminum alloy

Driver cover: flame retardant ABS engineering plastic Working medium: water

Medium temperature: less than 94 degrees Celsius

Operation and precautions

The motor cover prevents dripping water from penetrating. When the valve is installed in a horizontal pipeline, the angle between the installation position and the vertical plane should not exceed 85 degrees, as shown in Figure 2. When the valve is installed on a vertical pipe, the motor cover must prevent dripping water from penetrating. When moving the manual operating lever, it should be moved slowly. When the manual lever moves slowly along the arrow direction and is pressed into the gap and stuck, the valve is in the normally open state. Whenever the current first passes through the electric valve, the manual lever will be reset to the automatic position.

Installation Instructions

The installation of the singing and closing two way valve and the mixing three way valve is shown in Figures 3 and 4. For high-rise buildings, pressure reducing valves should be used on the bottom branch pipes of the bottom buildings. When installing the valve body, pay attention to the arrow direction of the valve body. If equipped with an auxiliary switch, its wiring is shown in Figure 6:

Previous: Wiring Diagram and Model Parameters of Dynamic Balancing Electric Regulating Valve for Fushan Valve

Next: Performance and Parameters of V4043 Series Switching Electric Valves for Fushan Valves

Copyright: Su ICP Bei 11005723-1

Tel: 0512-57775177

Address: Block G, No. 499, Yujinxiang Road, Kunshan City, Jiangsu Province